Skip to content
Bodek Tools

Add a logo and colours to a QR code

Brand your QR code with a logo in the middle and your own colours, and keep it easy to scan.

Updated · 3 min read

On this page
  1. Under 3. Logo (optional), select Choose image.
  2. Pick a PNG, JPEG, WebP or GIF image of up to 2 MB. SVG and other formats aren't supported. Large images are scaled down to 512 px.
  3. Use the Logo size slider to set how wide the logo is, from 5% to 25% of the code's width (20% by default). It's capped at 25% so the code still scans.
  4. Leave Rounded background padding around the logo switched on to put a clear, rounded area around the logo, or switch it off to place the logo directly on the code.

To take the logo out again, select Remove logo.

A simple, square logo with a solid or transparent background works best. Your logo is processed in your browser and never leaves your device unless you save the code.

Error correction

QR codes have built-in error correction, which lets them be read even when part of the pattern is covered. When you add a logo, Error correction is automatically set to High (30%) and locked, and you'll see "Set to High because a logo covers part of the code." The code may also become a little denser to leave room for the logo. If you remove the logo, your previous setting comes back.

Without a logo, you can choose Low (7%), Medium (15%) (the default), Quartile (25%) or High (30%) under 2. Design.

If the logo covers a lot of the code, you'll see a warning; make the logo smaller if phones struggle to scan it.

Choose colours

Under 2. Design, set Foreground (dots) and Background with the colour picker or by typing a hex code such as #1a2b3c. The Swap colours button switches them around. For reliable scanning:

  • Keep the code dark on a light background. Many scanners can't read light-on-dark codes, and you'll see a warning if the dots are lighter than the background.
  • Make the contrast strong. Black on white is safest; dark blue, dark green or dark red on white also work well. The generator warns you if the contrast is below 4.5:1, and shows a stronger warning below 3:1.
  • Avoid colours that are similar in brightness, such as red on green or grey on grey.

You can also set the Margin (quiet zone), the blank border around the code, from 0 to 10 modules. 4 is standard; below 2, scanning becomes less reliable.

Check it

After styling, scan the code with a couple of different phones, in the size you'll actually print it. If it doesn't scan easily, make the logo smaller or increase the contrast.

Still stuck? Contact support and we'll get back to you as soon as possible.